Mrs F has a commuting bike withThru Axles.
My knowledge of these is minimal.
The front one is seized, and the hex has rounded out.
I've cut a slot and tried to use a big screwdriver, but it just cams out.
An Ez-out might work, but I can't find my set right now.
The removal is going to be destructive however it's done now.
I am planning on just drilling it out on the threaded side.
That will work.
But what to replace it with?
Are these things generic?
I *think* it's 100 x 12, but a wee bit hard to measure in-situ.
The diameter of the threaded end seems very close to 12mm, and the length is a close to 100 as it's possible to measure through the disk and spokes.
So are these things generic?
Thru axle by
Ron Lowe, on Flickr