1
OT Knowledge / Re: Wall repair prep pre decorating
« Last post by Jurek on Today at 11:48:02 am »So I was thinking about replacing this 10mm quadrant with 15mm quadrant to hide the gap a bit once I've done the filling. But that's not going to work when I get to the horizontal bit here which isn't deep enough to take 15mm quadrant.Cut 3mm off one of the flats of the quadrant. Put that cut down flat against the wall. Trim the length of the diagonal quadrant at an angle so that end section fits the section of the horizontal quadrant.
PXL_20240419_151559263 by The Pingus, on Flickr
Any fantastic ideas? (Besides knock the house down and start again)