Author Topic: Geko / Memory Map  (Read 1138 times)

jellied

  • skip to the end
    • Ealing Bike Hub
Geko / Memory Map
« on: August 02, 2008, 12:50:08 pm »
Just tried to down load a route for tomorrow from Memory Map to my Garmin Geko 201. Never had previous problems

Says it can't find COM1, GPS time out etc.

The MM support forum is not working, but the FAQ suggests that something else might be polling the serial port. A likely culprit is my Nokia software - i unchecked it using the serial port, and then simply un-installed the Nokia software.

But alas - no joy.

How can I find out what if anything is using COM1? The FAQ mentions Windows Hyperterminal but doesn't actually say how to use it.
A shitter and a giggler.

frankly frankie

  • I kid you not
    • Fuchsiaphile
Re: Geko / Memory Map
« Reply #1 on: August 03, 2008, 04:48:37 pm »
You could try looking in Device Manager.
My Computer / System Properties / Hardware / Device Manager

There's an option under the View menu to view Devices by Connection (its not the default view, you have to select it)
you  can then scroll down looking for Communications Port COM 1 which will have a + by it if anything's connected, click on the + to expand the tree.

Also if you double-click on COM 1 to bring up its Properties box, there's a Resources tab which should show device conflicts if any.  Not an infallible guide, in my experience.
"This is a complex subject, with a need for more than one highlighter pen."

Re: Geko / Memory Map
« Reply #2 on: August 04, 2008, 06:25:07 pm »
This is a problem with Memory-Map, it often reallocates the ports.

The above system will enable you to identify the current port.