Another job is making a replacement crown guard for the circular-saw bench.
The original, plastic one is breaking apart.
A side is marked on sheet steel....
...and cut out on the guillotine.
Once cut, holes are drilled in the two sides to hold them together...
...so that they can be ground to matching shape.
Strips of steel are cut & bent to shape for the top, then tacked in place with the MIG welder.
The rest of the welding is done with the oxy torch. I'm normally neater at gas welding, but there were slight gaps to fill.
A bit of tube is cut with the angle grinder to fit in for the extractor port, and welded in with the MIG. The angle grinder is then employed to tidy it up.
Hopefully I'll get time to finish it tomorrow.