Author Topic: Failing self-inflating mats  (Read 912 times)

Failing self-inflating mats
« on: 10 August, 2021, 02:52:04 pm »
We’ve got a small collection of self-inflating mats. For light weight camping a couple of Thermarests and a couple of cheaper brand imitations, for car and big tent camps we’ve also got a couple of big Outwell mats.

Setting up the big tent at the start of a Tandem Rally last week I realised that the big thick double Outwell mat has failed, could be a small pin hole, or more likely a failed seem maybe. It has occurred to me since that over the past half dozen years we’ve had 3 mats fail in this way, all of them big thick Outwell’s, (the other two were singles however).

I’m wondering now whether it’s the increased depth that makes them more prone to failure or whether Outwell mats are just a bit naff?

Has anyone had any success in repairing self-inflating mats? They all have very slow leaks that are going to be very hard to detect.
 

Re: Failing self-inflating mats
« Reply #1 on: 10 August, 2021, 03:25:31 pm »
I currently have a large SIM, also Outwell, sitting behind me in the office after having failed to find a very slow leak. The wife has suggested taking it to the swimming pool and looking for bubbles, but other than that I'm out of ideas :(

Mrs Pingu

  • Who ate all the pies? Me
    • Twitter
Re: Failing self-inflating mats
« Reply #2 on: 12 August, 2021, 09:03:03 pm »
Paddling pool or bath?
Do not clench. It only makes it worse.

Re: Failing self-inflating mats
« Reply #3 on: 12 August, 2021, 09:21:46 pm »
Given that the majority of these products are not inexpensive and that technology has evolved to a stage where we can now glue wings to high performance aeroplanes why are such failures occuring and perhaps be considered acceptable?
Get a bicycle. You will never regret it, if you live- Mark Twain

Re: Failing self-inflating mats
« Reply #4 on: 13 August, 2021, 12:23:56 pm »
Because people aren't prepared to pay as much for a self-inflating mat as they are for a high performance aeroplane, so there's slightly less funding available for research into the properties of the most appropriate adhesive?

mmmmartin

  • BPB 1/1: PBP 0/1
    • FNRttC
Re: Failing self-inflating mats
« Reply #5 on: 02 September, 2021, 09:28:43 pm »
Would suggest a bath of water and time to sit and watch for the occasional bubble. Then the adhesive patch they usually give you, and once you add the glue and patch, stick a pot of hot water on it for about 15 minutes. Seemed strange to me when someone suggested it but it worked a treat. Hasn't failed since and that was years ago
Besides, it wouldn't be audacious if success were guaranteed.