Today I unpacked my Evolution Rage Table Saw. Fiddly slightly awkward process, I dropped two bolts into the machine. Found one when i turned it over. Not sure where the other has gone.
It's hiding inside the venturi tube.
This piece of wisdom is a hangover from
many years ago when I was putting a head back together and bolted the air intakes to the horizontal twin Webber DCOE probably that bit too late at night and, after probably half hour of searching, decided it must have fallen on the floor. As has been by now established, it hadn't and got sucked in a mile or so down the road
Even if the saw doesn't have a venturi tube, it will have something functionally similar.
In other news I dug up my Wolfcraft saw/router table over the weekend, it's a bench that allows you to convert a skill saw into a table saw, router into table router. While not perfect it does a job and has - thus far - prevented a splurge on something I have no room for.
ETA something like
this. only mine has a router hole and mount in it, too.